Heavy Hitter has produced an amazing upgrade for your favorite e-bike. The rear suspension linkage is a known weak point in the stock suspension setup. Many riders have complained about suspension noise and play since the bike was released.
That play means it's only a matter of time until bearing and linkage failure comes.
Our linkage is designed with 4mm of shock preload. Your linkage will lightly rest on the swingarm at full droop with the rear wheel off the ground. This is a huge advantage for all bikes! Most Mountain bike suspension does not include a top out control on the shock. Unfortunately, this leads to the shock shaft and seals slamming into the shock body at full droop. If this happens continuously, it will prematurely blow out your suspension seals and rebound control.
To prevent premature shock wear, we have designed the linkage to have 4mm of top out stop, similar to limiting straps found on Trophy trucks and side by sides. This will greatly increase the life of your shock and components - especially for heavier riders needing 550-650 lb. springs, and guys that love sending big jumps.
This will only fit the correct 10.5 x 3.5 inch, and smaller shocks! Longer shocks are not advised.
Note: Always grease bearings before riding!
Features
Made from 7075 Billet Aluminum
Steel bushings for a precision no slop fit
Pre-Assembled with new bearings, bushings, and seals
November 4–16: Buy an eligible in-stock Sur-Ron, E Ride Pro or Electro & Co. bike and receive a credit for a free set of tires at your first tire change.Ride it first. Find your terrain. Then choose the tread that fits—street, enduro or knobby. Your tire coupon is added to your order history, ready when you need it.One tire credit per eligible bike purchase. Tires are redeemed later, not shipped with your bike. Installation is not included. Cannot be combined with other discounts. Questions? Contact Radmoto.
